Power Probe Master Combo Kit - PPKIT03

Quickly check components for continuity as well as identify positive, negative and open circuits without re-polarizing hook-up clips

• 2 - white LEDs that flood the work area with bright light

Specifications:

• Maximum Voltage on Probe Tip: ± 200 Volts Relative to the Negative Battery Clip
• Probe tip resistance to ground 130KO Computer Safe: 0.1mA floating tip. Voltage range: 12-24v

Power Probe Mode (Mode 1)

• DC Voltage Measurement: 0 to 70 Volts (in 1/10th increments)
• AC Voltage Measurement: 0 to 70 Volts Peak to Peak
• (See Peak to Peak & Threshold Setting Mode 5)
• Square Wave Input Response: 15 Hz to over 500KHz
• Sine Wave Input Response: 35 Hz to over 250KHz
• Continuity to Ground: Greater than 20K Ohms - Display is Blank
• Less than 20K Ohms: Display reads 0.0
• Less than 2K Ohms: Display reads 0.0 and Green Led is On

Min (Mode 2) & Max (Mode 3)

• Voltage Measurement: 0 to 70 Volts
• Single Event Capture: Less than 200 Micro Second Pulse Width
• Repetitive Events: Less than 1 Micro Second Pulse Width

Peak to Peak Mode (Mode 4)

• 0 to 70 Volts P-P
• Square Wave Input Response: 4 Hz to over 500KHz
• Sine Wave Input Response: 4 Hz to over 250KH

Peak to Peak Mode Threshold Setting (Mode 5)

• 0.2, 0.5, 1, 2, 5, 10 & 50 When the Peak to Peak Voltage on the Probe Tip exceeds this threshold then the display is Peak
• to Peak AC rather than DC.
• Storage temperature: -40°C (-40°F) to 70°C (158°F)
• Operating temperature: -20°C (-4°F) to 60°C (140°F)

Circuit Breaker

• 8 amp thermal response - manual reset
• 8 amp=No trip
• 10 amps=20 min.
• 15 amps=6 sec.
• 25 amps=2 sec.
• Short circuit=0.3 sec.

AMP Ratings for Probes, Leads and Adapters

• 1, 3, 6' Leads: 30 amps
• Alligator Clip Lead: 20 amps
• Male-Male Adapter: 30 amps
• Female-Female Adapter: 30 amps
• Small Piercing Probe: 10 amps 20-28 Gauge
• Large Piercing Probe: 20 amps 8-18 Gauge
• Power Probe Tip: 30 amps